Based on our water metering devices are able to make any electronically controlled watering system.

We are able to control a certain amount of points the flow of water both in terms of time, releasing water as well as its temperature.
 

A description of an exemplary embodiment of an automatic watering temperature-controlled.

The system is designed to control watering from 1 to 17 units. Watering can be cyclic with a set period. Can also be watered individually once one of the objects.
Each watering cycle is always initiated switching outputs 18 treated as a discharge of water. The objective is to stabilize the temperature of the water before the actual start of irrigation facilities. It is recommended that the water temperature set in the discharge is the same as the water temperature to the object of the watering cycle starts.
For objects that do not have to be watered amount of water in the programs should be set to 0.0. The number of dispenser-mixer driver USP output corresponds to the number on the terminal block that is
Program No. 1 controls output No. 1 (object # 1), the program will exit no.2 No. 2, etc.
For each of the objects to program the amount of water and its temperature. The system is protected against wydozowaniem too hot water. Exceeding the critical temperature of hot water cuts.

The irrigation system consists of the following devices:
USP water dispenser mixer with programs
solenoid valves on the control bar objects from 1 to 17
elevated status indicator showing the driver in the dispenser - water mixer (optional)
24VAC power supply

Irrigation system is used in horticulture to cyclic watering or irrigation facilities such as greenhouses.
 

Description dispenser used - Mixer:

Dispenser-mixer USP is a device equipped with a microprocessor-based controller designed to measure the flow of water required at a specific temperature. Particularly useful is the amount of water needed in a variety of technological processes carried out periodically, which temperature plays an important role in such processes in the food industry (bakery, confectionery, pasta production, etc.)
USP dispenser-mixer is adapted to receive hot and cold water directly from the mains. It has a built-in mixer allows you quickly get water discharges at the desired temperature.
It is produced in the automatic version, in which the system installed in the device automatically sets the desired temperature of the water outflow. In version PROG Water Dispenser-Mixer software can be programmed amount of water. The program is stored quantity and temperature of the water outflow. A version dispenses preset programs periodically.
The device is continuously measured in both the amount of water flowing, as well as its temperature, and presents this information to the displays.
Having measured the amount of water set the device automatically closes the flow. The control unit is very comfortable and is done using the keys on the front panel of the controller.
USP dispenser-mixer can be mounted on a wall or stand. There are three typical hydraulic connections or tubing pipe unions ended (two for the water supply and one for water outflow).
 
 
To place an order please contact us by phone or email to arrange a watering system design.